Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1194

■ Procedure after Work
1) Install the Main Controller PCB 1 to the host machine.
CAUTION:
• Lift the grip and insert the Main Controller PCB 1 and then, after it stops, tilt the grip
and install it with 2 screws.
• Make sure to tilt the grip slowly on both sides simultaneously.
• Check that the Main Controller PCB 1 is installed properly.
9
Installation > Serial Interface Kit-K1/K2 / Copy Control Interface Kit-A1 > Installation Procedure > Procedure after Work
x2
Grips
F-9-330
9 Installation > Serial Interface Kit-K1/K2 / Copy Control Interface Kit-A1 > Installation Procedure > Procedure after Work
2) Install the USB Cable and the Control Panel Communication Cable.
3) When the Reader is installed, install the Reader Power Cable.
NOTE:
Handle the Reader Power Cable from the connector side and make a slack at [A] part.
Bend the Reader Power Cable at a right angle on [B] part.
x2
x2
Wire Saddles
4) Install the Right Rear Cover 1 (3 Screws).
5) Close the Right Lower Cover.
6) Close the Right Upper Cover.
7) Connect the power plug of the host machine to the power outlet.
8) Turn ON the main power switch.
9-124
[A]
Cable Guide
[B]
Reader Power Cable
Connectors
F-9-331
9-124