Setting After Installation - Canon imageRUNNER ADVANCE C5255 Series Service Manual

28) Remove the backing paper of Cord Guide and put it in the 2 places indicated in the
figure.
29) Remove the face seal, and install the wire saddle.
30) Put the Card Reader External Relay Harness through the 2 places of Cord Guide and
install the cover.
31) Fix the Card Reader External Relay Harness with the Wire Saddle.
NOTE:
Even when used in combination with following options, the routing of the cable is same.
• Voice Guidance Kit
9
Installation > Copy Card Reader-F1 > Setting After Installation
Wire saddle
Cord Guide
F-9-277
F-9-278
9 Installation > Copy Card Reader-F1 > Setting After Installation
32) Connect the power plug of the host machine to the power outlet.
33) Turn ON the main power switch.

Setting After Installation

1) Check that the following service mode value is set to "0".
• Service Mode (level 1) > COPIER > OPTION > ACC > CR-TYPE
NOTE:
The number of card (number of department) can be changed if a request arises from a
user. Make this setting before the step 3).
• Change the setting value in service mode (level 2) > [COPIER] > [OPTION] > [FNC-SW] >
[CARD-RNG].
• To enable the setting value, turn OFF/ON the main power switch.
• After that, go through the procedure from step 2).
2) Enter the following Service Mode (level 1).
3) Select: [COPIER] > [FUNCTION] > [INSTALL] > [CARD] and enter the card number to be
used (1 to 2001).
• Input the minimum card number to be used by a user.
• 1000 cards from the inputted number can be used.
4) To enable the setting value, turn OFF/ON the main power switch.
5) Insert the card with the registered card No. and make sure that it is in standby.
NOTE:
After setting, if a request arises from a user and changing the number of card (number
of department), make a following setting. In that case, the current counter information
by department will be reset.
• Execute in service mode (level 1) > [COPIER] > [FUNCTION] > [CLEAR] > [CARD].
• Specify the value in service mode (level 2) > [COPIER] > [OPTION] > [FNC-SW] >
[CARD-RNG].
• After that, go through the procedure from step 2).
9-105
9-105