Canon imageRUNNER ADVANCE C5255 Series Service Manual page 1287

CAUTION:
• Be sure to place the tags on the Power Supply Cable in the position where it is
beyond the wire saddle toward the HDD side.
• If returning the Controller Box while placing the cables and tags toward the PCB side,
they may interfere the fan on the host machine.
Wire Saddle
13) Close the HDD Lid. (1 Screw)
14) Place the Controller Box to the original position. (2 Screws or 3 Screws)
15) Install the removed cover and the cable.
• Rear Cover (2 Screws, 2 Rubber Caps)
• Left Rear Sub Cover (1 Screw)
• Reader Communication Cable (when reader is installed)
• Left Rear Cover (2 Screws, 2 Rubber Caps)
9
Installation > [TYPE-4] > Installation Procedure > Installing the Mirroring Board or Encryption Board
16)
NOTE:
Handle the Reader Power Cable from the connector side and make a slack at [A] part.
Bend the Reader Power Cable at a right angle on [B] part.
Tag
F-9-582
17)
9 Installation > [TYPE-4] > Installation Procedure > Installing the Mirroring Board or Encryption Board
If Reader is installed, install the Reader Power Cable.
x2
x2
Wire Saddles
Connectors
Install the Right Rear Cover 1. (3 Screws)
9-217
[A]
Cable Guide
[B]
Reader Power Cable
F-9-583
9-217