CHAPTER 15 8/16-BIT PPG TIMER
15.2 Registers of 8/16-bit PPG Timer
[bit10, bit9] MD1, MD0: ppg count Mode (operation mode selection)
The operation mode of the PPG timer is selected.
MD1
0
0
1
1
• These bits are initialized to "00
• Reading and writing are allowed.
Notes:
•
Please set neither MD1 nor MD0 bits in "10
•
Do not set the PPGC0:PEN0 bit and the PPGC1:PEN1 bit to "01
MD0 bits to "01
to "11
" or "00
B
•
Set the PEN0/PEN1 to "11
"11
" by updating the PPGC0/PPGC1 via the word transfer.
B
[bit8] Reserved bit
It is Reserved bit. Always set this bit to "1".
348
MD0
0
8-bit PPG 2 independent mode (The case multiplied by 2 is enabled).
1
8-bit prescaler + 8-bit PPG 1 channel.
0
Reserved (Setting prohibited).
1
16-bit PPG 1 channel mode (The case multiplied by 2 is enabled).
" at reset.
B
". In addition, the PEN0 and PEN1 bits are recommended to simultaneously set
B
".
B
" or "00
B
B
FUJITSU MICROELECTRONICS LIMITED
Operating mode
".
B
" simultaneously, when setting the MD1 and MD0 bits to
MB90335 Series
" when setting the MD1 and
B
CM44-10137-6E