Table of Contents
Advertisement
Chapter 1
Installing the Application Gateway
Configuring the Application Gateway for the First Time
6
7
Third-Party Software
14
Application Gateway Hardware Installation Guide
If they are correct, type y when asked to commit your changes. The
Application Gateway restarts and displays the login prompt.
If they are not correct, type n when asked to commit your changes, then
type 0 (Express Setup) to change settings.
To test the connection, verify that the Application Gateway can ping
connected network devices: Type 1 (Ping), press Enter, and enter the IP
address that you want to ping.
If the ping is successful, you have completed the initial configuration. If
the ping is not successful, check your connections, return to the serial
console Main Menu, and type 0 (Express Setup) to change settings as
needed.
To complete the Application Gateway configuration, refer to the
Administration Guide.
We recommend that you not install any third-party software on the
Application Gateway. Problems caused by the installation of third-party
software are not supported.
.
Advertisement
Table of Contents
