Figure 6-12 Two-Port Unidirectional Transponder Mode; Ntp- D149 Test G-Series Circuits - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
Figure 6-12
Stop. You have completed this procedure.
NTP-D149 Test G-Series Circuits
Purpose
Tools/Equipment
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
node. If you are already logged in, continue with Step 2.
Complete the
Step 2
ports to the Locked-enabled,maintenance service state.
78-17194-01
Two-Port Unidirectional Transponder Mode
This procedure tests circuits created on G-Series Ethernet cards.
Ethernet test set and appropriate fibers
the fibers and cables from the source and destination ONS 15454 SDHs to
the fiber distribution panel or the DSX, and one of the following
procedures:
NTP-D323 Create an Automatically Routed High-Order Circuit, page 6-55
NTP-D324 Create a Manually Routed High-Order Circuit, page 6-60
NTP-D148 Create a Manual Cross-Connect for a G-Series or E-Series Card
in Port-Mapped Mode, page 6-90
As needed
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D230 Change a Circuit State" task on page 19-26

NTP- D149 Test G-Series Circuits

at the ONS 15454 SDH source Ethernet
and change the circuit and circuit
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-95