Dlp- D172 Provision Additional Manual Area Addresses - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:
Table of Contents

Advertisement

DLP- D172 Provision Additional Manual Area Addresses

DLP-D172 Provision Additional Manual Area Addresses
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > OSI > Routers > Setup tabs.
Step 1
Chose the router where you want provision an additional manual area address and click Edit. The OSI
Step 2
Router Editor dialog box appears.
In the OSI Router Editor dialog box:
Step 3
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 4
DLP-D173 Enable the OSI Subnet on the LAN Interface
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
OSI subnetwork points of attachment are enabled on data communications channels (DCCs) when you
Note
create DCCs. See the
page 20-68
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-60
This task provisions the OSI manual area addresses. Three additional
manual areas can be created for each virtual router.
None
NTP-D24 Verify Card Installation, page 4-2
DLP-D171 Provision OSI Routers, page 18-59
As needed
Onsite or remote
Provisioning or higher
Check Enable Router to enable the router and make its primary area address available for editing.
Click the manual area address, then click Add.
In the Add Manual Area Address dialog box, enter the primary area address in the Area Address
field. If you prefer, click Use Mask and enter the address in the Masked NSAP Entry dialog box.
The address (hexadecimal format) can be 2to 24 alphanumeric characters (0–9, a–f) in length.
Click OK successively to close the following dialog boxes: Masked NSAP Entry (if used), Add
Manual Area Address, and OSI Router Editor.
This task enables the OSI subnetwork point of attachment on the LAN
interface.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
"DLP-D363 Provision Regenerator-Section DCC Terminations" task on
and the
"DLP-D364 Provision Multiplex-Section DCC Terminations" task on page
Chapter 18
DLPs D100 to D199
20-71.
78-17194-01

Advertisement

Table of Contents
loading

Table of Contents