Dlp- D180 Edit The Osi Subnetwork Point Of Attachment - Cisco ONS 15454 SDH Procedure Manual

DLP- D180 Edit the OSI Subnetwork Point of Attachment

c.
d.
Step 4 Return to your originating procedure (NTP).
DLP-D180 Edit the OSI Subnetwork Point of Attachment
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > Routers > Subnet tabs.
Step 1
Choose the subnet you want to edit, then click Edit.
Step 2
In the Edit <subnet type> Subnet <slot/port> dialog box, edit the following fields:
Step 3
•
•
•
Note
Click OK.
Return to your originating procedure (NTP).
Step 4
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-68
If you want to add or edit an area address to the primary area, enter the address at the bottom of the
Multiple Area Addresses area. The area address can be 2 to 26 numeric characters (0–9) in length.
Click Add.
Click OK.
This task allows you to view and edit the OSI subnetwork point of
attachment parameters. The parameters are initially provisioned when you
create a Section DCC (SDCC), Line DCC (LDCC), generic
communications channel (GCC), or optical service channel (OSC), or when
you enable the LAN subnet.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
ESH—The End System Hello PDU propagation frequency. An end system NE transmits ESHs to
inform other ESs and ISs about the NSAPs it serves. The default is 10 seconds. The range is 10 to
1000 seconds.
ISH—The Intermediate System Hello PDU propagation frequency. An intermediate system NE
sends ISHs to other ESs and ISs to inform them about the NETs it serves. The default is 10 seconds.
The range is 10 to 1000 seconds.
IIH—The Intermediate System to Intermediate System Hello PDU propagation frequency. The IS-IS
Hello PDUs establish and maintain adjacencies between ISs. The default is 3 seconds. The range is
1 to 600 seconds.
The IS-IS Cost and DIS Priority parameters are provisioned when you create or enable a subnet.
You cannot change the parameters after the subnet is created. To change the DIS Priority and
IS-IS Cost parameters, delete the subnet and create a new one.
Chapter 18 DLPs D100 to D199
78-17194-01