Dlp- D332 Install The Tcc2/Tcc2P Cards - Cisco ONS 15454 SDH Procedure Manual

DLP- D332 Install the TCC2/TCC2P Cards

Return to your originating procedure (NTP).
Step 4
DLP-D332 Install the TCC2/TCC2P Cards
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
When installing cards, allow each card to boot completely before installing the next card.
Note
Open the latches/ejectors of the TCC2/TCC2P card that you will install.
Step 1
Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
Step 2
receptacle at the back of the slot (Slot 7 or 11).
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Step 3
Note
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Go to Step
Step 4
a.
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-22
This task installs redundant TCC2/TCC2P cards. The first card you install
in the ONS 15454 SDH must be a TCC2/TCC2P card, and it must initialize
before you install any cross-connect or traffic cards.
Two TCC2/TCC2P cards
Required
Onsite
None
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
a to verify the LED activity on the TCC2 card. For the TCC2P card, go to Step b.
For the TCC2 card:
• All LEDs turn on briefly. The red FAIL LED and the yellow ACT/STBY LED turn on for about
15 seconds.
The red FAIL LED and the green ACT/STBY LED turn on for about 40 seconds.
•
• The red FAIL LED blinks for about 15 seconds.
• The red FAIL LED turns on for about 15 seconds. All LEDs turn on for about 3 seconds before
turning off for about 3 seconds.
Both green PWR LEDs turn on for 10 seconds. The PWR LEDs then turn red for 2 to 3 minutes
•
before going to steady green.
While the PWR LEDs are red for two to three minutes, the ACT/STBY, MJ, and MN LEDs turn
•
on, followed by the SNYC LED.
The boot up process is complete when the PWR LEDs turn green and the ACT/STBY remains
•
on. (The ACT/STBY LED will be green if this is the first TCC2 card installed, and amber if this
is the second TCC2 card installed.)
Chapter 20 DLPs D300 to D399
78-17194-01