Table 20-15 Line Threshold Options For E3-12 Cards - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
Table 20-14
Parameter
Service
State
AINS Soak
Table 20-15
near-end line threshold options are supported for this card.
Table 20-15
Parameter
Port
CV
ES
SES
LOSS
15 Min radio button
1 Day radio button
78-17194-01
Line Options for E3-12 Cards (continued)
Description
(Display only) Identifies the
autonomously generated state that gives
the overall condition of the port. Service
states appear in the format: Primary
State-Primary State Qualifier, Secondary
State. For more information about service
states, refer to the "Administrative and
Service States" appendix of the
Cisco ONS 15454 SDH Reference
Manual.
Sets the automatic in-service soak period.
describes the values on the Provisioning > Line Thresholds tab for the E3-12 cards. Only
Line Threshold Options for E3-12 Cards
Description
(Display only) Port number; 1 to 12.
Coding violations.
Errored seconds.
Severely errored seconds.
Loss of signal seconds; number of one-second intervals containing one or
more LOS defects.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 15-minute intervals.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 1-day intervals.
DLP- D340 Change Line and Threshold Settings for the E3-12 Cards
Options
Unlocked-enabled—The port is fully
•
operational and performing as
provisioned.
• Unlocked-disabled,automaticInService—
The port is out-of-service, but traffic is
carried. Alarm reporting is suppressed.
The ONS node monitors the ports for an
error-free signal. After an error-free
signal is detected, the port stays in the
Unlocked-disabled,automaticInService
state for the duration of the soak period.
After the soak period ends, the port
service state changes to
Unlocked-enabled.
Locked-enabled,disabled—The port is
•
out-of-service and unable to carry
traffic.
• Locked-enabled,maintenance—The port
is out-of-service for maintenance.
Alarm reporting is suppressed, but
traffic is carried and loopbacks are
allowed.
Duration of valid input signal, in hh.mm
•
format, after which the card becomes
Unlocked-enabled automatically
0 to 48 hours, 15-minute increments
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-45