Figure - Cisco ONS 15454 SDH Procedure Manual

Chapter 13 Convert Network Configurations
Note
Enter the node host name or IP address or choose the name of the new node from the drop-down list. If
Step 6
you type in the name, make sure it is identical to the actual node name. The node name is case sensitive.
When you have the name of the node in the menu, click Next. The Select Protection Group Ports page
Step 7
appears
From the drop-down lists, select the working and protect ports on the new node that you want to connect
Step 8
to each terminal node.

Figure 13-1

Click Next. The Re-fiber the Protected Path dialog box appears
Step 9
Figure 13-2
Step 10 Follow the instructions on the page for connecting the fibers between the nodes.
78-17194-01
If you are attempting to add an unreachable node you must first log in to the unreachable node
using a separate CTC session and configure that node. Delete any existing protection groups as
described in the "DLP-D155 Delete a Protection Group" task on page
SDH DCC terminations as described in the
Termination" task on page
(Figure 13-1).
Selecting Protection Group Ports
Refibering the Protect Path
NTP- D338 Convert a Point-to-Point to a Linear ADM Automatically
"DLP-D360 Delete a Regenerator-Section DCC
20-66.
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-47. Delete any existing
(Figure 13-2).
13-3