Dlp- D37 Reset A Tcc2/Tcc2P Card Using Ctc - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
DLP-D37 Reset a TCC2/TCC2P Card Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard. Statement 206
When CTC is used to reset a TCC2/TCC2P card, the system ensures that the database is protected from
Note
harm.
When a software reset is performed on an active TCC2/TCC2P, the AIC-I card goes through an
Note
initialization process and also resets. The AIC-I card reset is normal and happens each time an active
TCC2/TCC2P card goes through a software-initiated reset.
In node view, right-click the TCC2/TCC2P card to reveal a shortcut menu.
Step 1
Click Reset Card.
Step 2
Click Yes when the confirmation dialog box appears.
Step 3
Click OK when the "Lost connection to node, changing to Network View" message appears.
Step 4
Note
Confirm that the TCC2/TCC2P card LED is amber (standby).
Step 5
Step 6 Return to your originating procedure (NTP)
78-17194-01
This procedure resets the TCC2/TCC2P card and switches the node to
the redundant TCC2/TCC2P.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser
For LED behavior during a TCC2/TCC2P reboot, see

DLP- D37 Reset a TCC2/TCC2P Card Using CTC

Table 19-4 on page
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-55.
17-29