Cisco ONS 15454 SDH Procedure Manual page 460

DLP- D53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454 SDH
Test the connection:
Step 6
Start Netscape Navigator.
a.
Enter the Cisco ONS 15454 SDH IP address in the web address (URL) field. If the connection is
b.
established, a Java Console window, CTC caching messages, and the Cisco Transport Controller
Login dialog box appear. If this occurs, go to Step 2 of the
page 17-49
At the prompt, type:
c.
ping ONS-15454-SDH-IP-address
For example, to connect to an ONS 15454 SDH with a default IP address of 192.1.0.2, type:
ping 192.1.0.2
If your workstation is connected to the ONS 15454 SDH, the following message appears:
IP-address is alive
Note
d. If CTC is not responding, a "Request timed out" (Windows) or a "no answer from x.x.x.x" (UNIX)
message appears. Verify the IP and subnet mask information. Check that the cables connecting the
workstation to the ONS 15454 SDH are securely attached. Check the link status by typing:
# ndd -set /dev/device instance 0
# ndd -get /dev/device link_status
For example:
# ndd -set /dev/hme instance 0
# ndd -get /dev/hme link_status
A result of 1 means that the link is up. A result of 0 means that the link is down.
Note
Step 7 Return to your originating procedure (NTP).
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-46
to complete the login. If the Login dialog box does not appear, complete Steps
Skip this step if you checked Craft Access Only at Provisioning > Network > General >
Gateway Settings.
Check the man page for ndd. For example, type man ndd at the prompt.
Chapter 17 DLPs D1 to D99
"DLP-D60 Log into CTC" task on
c and d.
78-17194-01