Table 20-19 Line Threshold Options For The Ds3I-N-12 Cards - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
Table 20-18
Parameter
Service
State
AINS Soak Sets the automatic in-service soak
Table 20-19
Only near-end line threshold options are supported for this card.
Table 20-19
Parameter
Port
CV
ES
SES
LOSS
15 Min radio button
1 Day radio button
Table 20-20
cards.
78-17194-01
Line Options for the DS3i-N-12 Cards (continued)
Description
(Display only) Identifies the
autonomously generated state that gives
the overall condition of the port. Service
states appear in the format: Primary
State-Primary State Qualifier, Secondary
State. For more information about
service states, refer to the
"Administrative and Service States"
appendix of the Cisco ONS 15454 SDH
Reference Manual.
period.
describes the values on the Provisioning > Line Thresholds tab for the DS3i-N-12 cards.
Line Threshold Options for the DS3i-N-12 Cards
Description
(Display only) Port number; 1 to 12.
Coding violations.
Errored seconds.
Severely errored seconds.
Loss of signal seconds; number of one-second intervals containing one or
more LOS defects.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 15-minute intervals.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 1-day intervals.
describes the parameters on the Provisioning > Elect Path Thresholds tab for the DS3i-N-12
DLP- D341 Change Line and Threshold Settings for the DS3i-N-12 Cards
Options
Unlocked-enabled—The port is fully
•
operational and performing as
provisioned.
• Unlocked-disabled,automaticInService—
The port is out-of-service, but traffic is
carried. Alarm reporting is suppressed.
The ONS node monitors the ports for an
error-free signal. After an error-free
signal is detected, the port stays in the
Unlocked-disabled,automaticInService
state for the duration of the soak period.
After the soak period ends, the port
service state changes to
Unlocked-enabled.
Locked-enabled,disabled—The port is
•
out-of-service and unable to carry traffic.
Locked-enabled,maintenance—The port
•
is out-of-service for maintenance. Alarm
reporting is suppressed, but traffic is
carried and loopbacks are allowed.
Duration of valid input signal, in hh.mm
•
format, after which the card becomes in
Unlocked-enabled automatically
0 to 48 hours, 15-minute increments
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-49