Cisco ONS 15454 SDH Procedure Manual page 651

Chapter 19 DLPs D200 to D299
Click the Provisioning > Network > General tabs.
Step 2
Complete the following information in the fields listed:
Step 3
IP Address—Type the IP address assigned to the ONS 15454 SDH node.
•
Suppress CTC IP Display—Select this check box if you want to prevent the node IP address from
•
being displayed in CTC to users with Provisioner, Maintenance, or Retrieve security levels. (The IP
address suppression is not applied to users with Superuser security level.)
• LCD IP Display—Choose one of the following:
–
–
–
Default Router—If the ONS 15454 SDH is connected to a LAN, enter the IP address of the default
•
router. The default router forwards packets to network devices that the ONS 15454 SDH cannot
directly access. This field is ignored if any of the following are true:
–
–
–
Forward DHCP Request To—Select this check box to enable DHCP. Also, enter the DHCP server IP
•
address in the Request To field. The box is unchecked by default. If you will enable any of the
gateway settings to implement the ONS 15454 SDH proxy server features, leave this field blank.
Note
MAC Address—(Display only) Displays the ONS 15454 SDH IEEE 802 MAC address.
•
Net/Subnet Mask Length—Type the subnet mask length (decimal number representing the subnet
•
mask length in bits) or click the arrows to adjust the subnet mask length. The subnet mask length is
the same for all ONS 15454 SDH nodes in the same subnet.
TCC CORBA (IIOP) Listener Port—Sets the ONS 15454 SDH IIOP listener port used to
•
communicate between the ONS 15454 SDH and CTC computers. This field is generally not changed
unless the ONS 15454 SDH resides behind a firewall that requires a different port. See the
"NTP-D27 Set Up the ONS 15454 SDH for Firewall Access" procedure on page 4-8
information.
• Gateway Settings—Provisions ONS 15454 SDH SOCK proxy server features. Do not select any of
these options until you review the SOCKS proxy server scenario in the "Management Network
Connectivity" chapter in the Cisco ONS 15454 SDH Reference Manual. In proxy server networks,
the ONS 15454 SDH is either an ENE, a GNE, or a SOCKS proxy-only server. Provisioning must
be consistent for each network element (NE) type.
78-17194-01
Allow Configuration—(Default) Displays the node IP on the front panel LCD and allows it to
be changed using the ONS 15454 SDH LCD. This option enables the
Address, Default Router, and Network Mask Using the LCD" task on page
Display Only—Displays the node IP address on the front panel LCD but does not allow it to be
changed.
Suppress Display—Suppresses the node IP address display on the front panel LCD.
The ONS 15454 SDH is not connected to a LAN.
SOCKS proxy server is enabled and the ONS 15454 SDH is provisioned as an end network
element (ENE).
Open Shortest Path First (OSPF) is enabled on both the ONS 15454 SDH and the LAN where
the ONS 15454 SDH is connected.
If you enable DHCP, computers connected to an ONS 15454 SDH node can obtain
temporary IP addresses from an external DHCP server. The ONS 15454 SDH only forwards
DHCP requests; it does not act as a DHCP server.
DLP- D249 Provision IP Settings
"DLP-D64 Set the IP
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-53.
for more
19-53