Chapter 6
Create Circuits and Low-Order Tunnels
Figure 6-13
Click Next.
Step 8
Complete the
Step 9
VCAT circuit you are creating.
In the VCAT Circuit Routing Preferences area
Step 10
are available; choose either, both, or none based on your preferences.
•
Using Required Nodes/Spans—Check this check box to specify nodes and spans to include or
exclude in the CTC-generated circuit route.
Including nodes and spans for a circuit ensures that those nodes and spans are in the working path
of the circuit (but not the protect path). Excluding nodes and spans ensures that the nodes and spans
are not in the working or protect path of the circuit.
Review Route Before Creation—Check this check box to review and edit the circuit route before the
•
circuit is created.
Figure 6-14
78-17194-01
Setting VCAT Circuit Attributes
"DLP-D36 Provision a VCAT Circuit Source and Destination" task on page 17-28
Automatically Routing a VCAT Circuit
NTP- D283 Create an Automatically Routed VCAT Circuit
(Figure
6-14), check Route Automatically. Two options
Cisco ONS 15454 SDH Procedure Guide, R7.0
for the
6-99