Dlp- D135 Delete A Ppm From The Mrc-12 Or Stm64-Xfp Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
Click Yes in the Confirm Port Rate Change dialog box.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-D135 Delete a PPM from the MRC-12 or STM64-XFP Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Before deleting a PPM, delete the PPM from the provisioning pane.
Note
Step 1 Determine if the PPM can be deleted.
You cannot delete a port on a PPM if it is in service, part of a protection group, has a communications
channel termination in use, is used as a timing source, has circuits, or has overhead circuits. As needed,
complete the following procedures and tasks:
•
•
•
•
•
•
Step 2 In node view, double-click the MRC-12 or STM64-XFP card where you want to delete PPM settings.
Click the Provisioning > Pluggable Port Modules tabs.
Step 3
To delete a PPM and the associated ports:
Step 4
a.
b.
c.
Verify that the PPM provisioning is deleted:
Step 5
•
78-17194-01
This task deletes PPM provisioning for SFPs on the MRC-12 or
STM64-XFP card.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
DLP-D150 Modify a 1:1 Protection Group, page 18-42
NTP-D85 Change Node Timing, page 11-6
NTP-D277 Modify or Delete Communications Channel Terminations and Provisionable
Patchcords, page 11-5
NTP-D287 Modify and Delete Circuits, page 7-4
NTP-D288 Modify and Delete Overhead Circuits and Server Trails, page 7-4
DLP-D214 Change the Service State for a Port, page 19-10
Click the PPM line that appears in the Pluggable Port Modules area. The highlight changes to dark
blue.
Click Delete. The Delete PPM dialog box appears.
Click Yes. The PPM provisioning is removed from the Pluggable Port Modules area and the
Pluggable Ports area.
If the PPM was preprovisioned, CTC shows an empty slot in CTC after it is deleted.

DLP- D135 Delete a PPM from the MRC-12 or STM64-XFP Card

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-29