Dlp- D106 View And Terminate Active Logins - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:
Table of Contents

Advertisement

Chapter 18
DLPs D100 to D199
Note
Click Edit to make changes to an existing RADIUS server. You can change the IP address, the shared
Step 8
secret, the authentication port, and the accounting port.
Click Delete to delete the selected RADIUS server.
Step 9
Click Move Up or Move Down to reorder the list of RADIUS authenticators. The node requests
Step 10
authentication from the servers sequentially from top to bottom. If one server is unreachable, the node
will request authentication from the next RADIUS server on the list.
Click the Enable RADIUS Authentication check box to activate remote-server authentication for the
Step 11
node.
Click the Enable RADIUS Accounting check box if you want to show RADIUS authentication
Step 12
information in the audit trail.
Click the Enable the Node as the Final Authenticator check box if you want the node to be the final
Step 13
autheticator. This means that if every RADIUS authenticator is unavailable, the node will authenticate
the login rather than locking the user out.
Click Apply to save all changes or Reset to clear all changes.
Step 14
Return to your originating procedure (NTP).
Step 15
DLP-D106 View and Terminate Active Logins
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Active Logins tabs. The Active Logins subtab
Step 1
displays the following information:
Step 2
Click Logout to end the session of every logged-in user. This will log out all current users, excluding
the initiating Superuser.
78-17194-01
You can add up to 10 RADIUS servers to a node's list of authenticators.
This procedure allows you to view active CTC logins, retrieve the last
activity time, and terminate all current logins.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher for viewing; Superuser for session termination
User ID
User IP address
Current node the user is logged into
Session Type (EMS, TL1, FTP, Telnet, or SSH)
Login time
Last activity time

DLP- D106 View and Terminate Active Logins

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-7

Advertisement

Table of Contents
loading

Table of Contents