Before You Begin - Cisco ONS 15454 SDH Procedure Manual

Add and Remove Nodes
This chapter explains how to add and remove Cisco ONS 15454 SDH nodes from multiplex
section-shared protection rings (MS-SPRings), subnetwork connection protection (SNCP) rings, and
linear add/drop multiplexer (ADM) configurations.

Before You Begin

Before performing any of the following procedures, complete the
Provisioning" procedure on page
to the Cisco ONS 15454 SDH Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
78-17194-01
NTP-D353 Add an MS-SPRing Node, page
NTP-D213 Remove an MS-SPRing Node, page
NTP-D105 Add an SNCP Node, page
NTP-D106 Remove an SNCP Node, page
NTP-D280 Add a Node to a Linear ADM Manually, page
to the end of a linear ADM. This procedure can be used to add a node between two linear ADM
nodes, but requires that circuits be deleted and recreated. To add a node without disrupting traffic,
use the following procedure.
NTP-D337 Add a Node to a Linear ADM Using the Wizard, page
add a node between two linear ADM nodes.
NTP-D322 Remove an In-Service Node from a Linear ADM, page
remove a node from a linear ADM without disrupting traffic.
9-2. Also investigate all alarms and clear any trouble conditions. Refer
14-2—Complete as needed.
14-7—Complete as needed.
14-10—Complete as needed.
14-12—Complete as needed.
Cisco ONS 15454 SDH Procedure Guide, R7.0
14
C H A P T E R
"NTP-D195 Document Existing
14-14—Complete as needed to add a node
14-15—Complete as needed to
14-18—Complete as needed to
14-1