Dlp- D5 Mount The Shelf Assembly In A Rack (One Person) - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:
Table of Contents

Advertisement

DLP- D5 Mount the Shelf Assembly in a Rack (One Person)

In the Circuit Source area, complete the following:
Step 6
Click Next.
Step 7
In the Circuit Destination area, complete the following:
Step 8
Step 9
Click Finish.
Step 10
Put the ports that are hosting the IP-encapsulated tunnel in service. See the
Service State for a Port" task on page 19-10
Return to your originating procedure (NTP).
Step 11
DLP-D5 Mount the Shelf Assembly in a Rack (One Person)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The ONS 15454 SDH requires 616.5 mm (24.24 inch) minimum of vertical rack space and 25 mm
Note
(1 inch) below the installed shelf assembly to allow air flow to the fan intake. If a second
ONS 15454 SDH is installed above a shelf assembly, the air ramp between the shelves provides space
for air flow. To ensure the mounting is secure, use two to four M6 mounting screws for each side of the
shelf assembly. A shelf assembly should be mounted at the bottom of the rack if it is the only unit in the
rack.
Step 1
Verify that the chassis fuses rating does not exceed 30A.
Ensure that the shelf assembly is set for the desired rack size.
Step 2
position for the ONS 15454 SDH.
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-4
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Channel—Displays IPT (D1-D3).
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
Channel—Displays IPT (D1-D3).
This task allows one person to mount the shelf assembly in a rack.
Pinned hex tool
Two M6 x 20 socket set screws
Eight M6 x20 pan-head Phillips mounting screws
#2 Phillips screwdriver
NTP-D1 Unpack and Inspect the ONS 15454 SDH Shelf Assembly, page
1-4
As needed
Onsite
None
for instructions.
Figure 17-1
Chapter 17
DLPs D1 to D99
"DLP-D214 Change the
shows the rack-mounting
78-17194-01

Advertisement

Table of Contents
loading

Table of Contents