100-Gb Network Module (Two Ports, Single Wide) - Cisco Firepower 9300 Hardware Installation Manual

Overview

100-Gb Network Module (Two Ports, Single Wide)

The following figure shows the front panel of the 100-Gb network module (FPR9K-NM-2X100G). The
FPR9K-NM-2X100G is a single-wide module that supports hot swapping. The two ports are numbered left
to right.
Note Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
FXOS Compatibility
Figure 11: FPR9K-NM-2X100G
1
3
5
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
for the software compatibility matrix.
Power LED
Network activity LEDs
• Off—No connection or port is not in use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
Ethernet X/2
100-Gb Network Module (Two Ports, Single Wide)
Guide. See
2 Network activity LEDs
• Off—No connection or port is not in use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
4 Ethernet X/1
Captive screw/handle
6
Cisco Firepower 9300 Hardware Installation Guide
Cisco Firepower 4100/9300
19