Dlp- D96 Provision A Low-Order Vc3 Circuit Route - Cisco ONS 15454 SDH Procedure Manual

DLP- D96 Provision a Low-Order VC3 Circuit Route

From the TUG2 drop-down list, choose the source TUG2.
Step 5
From the VC12 drop-down list, choose the source VC12.
Step 6
If you need to create a secondary source, for example, an SNCP ring bridge/selector circuit entry point
Step 7
in a multivendor SNCP ring, click Use Secondary Source and repeat Steps
secondary source. If you do not need to create a secondary source, continue with
Step 8 Click Next.
Step 9 From the Node drop-down list, choose the destination (termination) node.
From the Slot drop-down list, choose the slot containing the destination card. The destination is typically
Step 10
a E1 card. However, you can also choose an STM-N card to map the VC12 to a VC4 for optical transport.
Step 11 Depending on the destination card, choose the destination port from the drop-down lists that appear
based on the card selected in
not show ports, VC4s, TUG3s, TUG2s, or VC12s already used by other circuits. If you and a user
working on the same network choose the same VC4, TUG3, TUG2, or VC12 simultaneously, one of you
receives a Path in Use error and is unable to complete the circuit. The user with the incomplete circuit
needs to choose new destination parameters.
If you need to create a secondary destination, for example, an SNCP ring bridge/selector circuit exit
Step 12
point in a multivendor SNCP ring, click Use Secondary Destination and repeat Steps
define the secondary destination.
Step 13 Click Next.
Step 14 Return to your originating procedure (NTP).
DLP-D96 Provision a Low-Order VC3 Circuit Route
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Route Review/Edit area of the Circuit Creation wizard, click the source node icon if it is not
Step 1
already selected.
Step 2 Starting with a span on the source node, click the arrow of the span that you want the circuit to travel.
The arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source VC3 appears.
If you want to change the source VC3, adjust the Source VC3 field; otherwise, continue with
Step 3
Step 4 If you want to change the source VC4, adjust the Source VC4 field; otherwise, continue with
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-94
Step 10. See Table 6-2 on page 6-3
This task provisions the circuit route for manually routed low-order VC3
circuits.
None
DLP-D60 Log into CTC, page 17-49
NTP-D55 Create a Manually Routed Low-Order VC3 Circuit, page 6-35
You must have the Route Review/Edit page of the Circuit Creation wizard
open.
As needed
Onsite or remote
Provisioning or higher
Chapter 17 DLPs D1 to D99
1 through 6 to define the
Step 8.
for a list of valid options. CTC does
9 through 11 to
Step 4.
Step 5.
78-17194-01