Dlp- D466 Delete Fc_Mr-4 Rmon Alarm Thresholds - Cisco ONS 15454 SDH Procedure Manual

DLP- D466 Delete FC_MR-4 RMON Alarm Thresholds

triggers when the rising threshold is crossed. An event is triggered only the first time a rising threshold
is exceeded (otherwise, a single network problem might cause a rising threshold to be exceeded multiple
times and cause a flood of events).
Click OK to complete the procedure.
Step 12
Step 13 Return to your originating procedure (NTP).
DLP-D466 Delete FC_MR-4 RMON Alarm Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the FC_MR-4 card where you want to delete the RMON alarm thresholds.
Step 1
In card view, click the Provisioning > Line Thresholds tabs.
Step 2
Click the RMON alarm threshold you want to delete.
Step 3
Click Delete. The Delete Threshold dialog box appears.
Step 4
Click Yes to delete that threshold.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D468 Create a Two-Fiber MS-SPRing Using the MS-SPRing Wizard
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > MS-SPRing tabs.
Step 2
Click Create MS-SPRing.
Step 3
In the MS-SPRing Creation dialog box, set the MS-SPRing properties:
Step 4
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-44
This task deletes RMON threshold crossing alarms for FC_MR-4 ports.
None
DLP-D465 Create FC_MR-4 RMON Alarm Thresholds, page 21-40
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
This task creates a two-fiber MS-SPRing using the MS-SPRing wizard.
None
DLP-D60 Log into CTC, page 17-49
As needed; required to complete MS-SPRing setup
Onsite or remote
Provisioning or higher
Ring Type—Choose two-fiber.
Chapter 21 DLPs D400 to D499
78-17194-01