Ntp- D79 Create A J1 Or J2 Path Trace - Cisco ONS 15454 SDH Procedure Manual

NTP- D79 Create a J1 or J2 Path Trace

NTP-D79 Create a J1 or J2 Path Trace
Purpose
Tools/Equipment
Prerequisite Procedures J1 path trace can be provisioned on VC3 and VC4 circuits. J2 path trace
Required/As Needed
Onsite/Remote
Security Level
There are two types of J1 bytes, high-order (HO-J1) and low-order (LO-J1). The electrical cards support
Note
LO-J1 (VC3). The optical cards support HO-J1 (VC4) and cannot monitor the LO-J1 byte. In addition,
the E1-42 card supports HO-J1 when the card is provisioned as an HO circuit endpoint.
Note J1 path trace is available for VC3 and VC4 circuits. In ONS 15454 SDH Software R3.4 and earlier, you
can set the VC3 J1 transmit string on E3 and DS3i-N-12 cards, but VC3 is not monitored by STM-N
cards. J2 path trace is available for VC12 circuits.
Complete the
Step 1
create the path trace. If you are already logged in, continue with Step 2.
Complete the following tasks as needed:
Step 2
•
•
•
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
7-8
This procedure creates a repeated, fixed-length string of characters used to
monitor changes to circuit traffic.
ONS 15454 SDH cards capable of transmitting and/or receiving path trace
must be installed. See
cards. See
can be provisioned on VC12 circuits. See
Low-Order Tunnels,"
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
As needed, complete the "DLP-D264 Provision a J1 Path Trace on Circuit Source and Destination
Ports" task on page 19-68.
As needed, complete the "DLP-D137 Provision a J1 Path Trace on STM-N Ports" task on
page 18-31.
As needed, complete the "DLP-D367 Provision a J2 Path Trace on Circuit Source and Destination
Ports" task on page 20-72.
Table 19-5 on page 19-68
Table 20-30 on page 20-73
for circuit creation procedures.
at a node on the network where you will
Chapter 7 Manage Circuits
for a list of J1 path trace
for a list of J2 path trace cards.
Chapter 6, "Create Circuits and
78-17194-01