Dlp- D75 Create A New User On Multiple Nodes - Cisco ONS 15454 SDH Procedure Manual

DLP- D75 Create a New User on Multiple Nodes

Note
Click OK.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-D75 Create a New User on Multiple Nodes
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
All nodes where you want to add users must be accessible in network view.
Note
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Security > Users tabs.
Step 2
In the Security window, click Create.
Step 3
In the Create User dialog box, enter the following:
Step 4
•
•
•
•
Note
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-66
Each security level has a different idle time. The idle time is the length of time that CTC can
remain idle before the password must be reentered. The defaults are: Retrieve user = unlimited,
Maintenance user = 60 minutes, Provisioning user = 30 minutes, and Superuser = 15 minutes.
To change the idle times, refer to the
on page 11-7.
This task adds a new user to multiple ONS 15454 SDH nodes.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser
Name—Type the user name. The name must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) characters.
Password—Type the user password. The password must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special (+, #, %) characters, where at least two characters are
nonalphabetic and at least one character is a special character.
Confirm Password—Type the password again to confirm it.
Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the "Security" chapter in the Cisco ONS 15454 SDH
Reference Manual for information about the capabilities provided with each level.
Each security level has a different idle time. The idle time is the length of time that CTC can
remain idle before it locks up and the password must be reentered. The defaults are: Retrieve
user = unlimited, Maintenance user = 60 minutes, Provisioning user = 30 minutes, and
Superuser = 15 minutes. To change the idle times, refer to the
Change Security" procedure on page
"NTP-D205 Modify Users and Change Security" procedure
11-7.
Chapter 17 DLPs D1 to D99
"NTP-D205 Modify Users and
78-17194-01