Dlp- D117 Apply Alarm Profiles To Cards And Nodes - Cisco ONS 15454 SDH Procedure Manual

DLP- D117 Apply Alarm Profiles to Cards and Nodes

An exclusion rule eliminates all lower-level alarms or conditions that originate from the same cause. For
example, a fiber break might cause an LOS alarm, an alarm indication signal (AIS) condition, and a
signal failure (SF) condition. If you check the Exclude Same Root Cause check box, only the LOS alarm
will appear.
Return to your originating procedure (NTP).
Step 4
DLP-D117 Apply Alarm Profiles to Cards and Nodes
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Alarm Profiles > Alarm Profile Editor tab
Step 1
Figure 18-6
To apply profiles to a card:
Step 2
a.
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-18
This task applies a custom or default alarm profile to cards or nodes.
None
DLP-D425 Create a New or Cloned Alarm Severity Profile, page 21-6
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Node View Alarm Profile
Click the Profile row for the card.
Chapter 18 DLPs D100 to D199
(Figure 18-6).
78-17194-01