Dlp- D32 Inspect The Shelf Installation And Connections - Cisco ONS 15454 SDH Procedure Manual

DLP- D32 Inspect the Shelf Installation and Connections

Click the overhead circuit that you want to delete: local or express orderwire, user data channel,
Step 3
IP-encapsulated tunnel, or DCC tunnel.
Step 4 Click Delete.
In the confirmation dialog box, click Yes to continue.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D32 Inspect the Shelf Installation and Connections
Purpose
Tools/Equipment
Prerequisite Procedures Complete
Required/As Needed
Onsite/Remote
Security Level
Check each wire and cable connection to make sure that all cables are locked securely. If a wire or cable
Step 1
is loose, return to the appropriate procedure in
To check that the front door is seated correctly, verify that it can be easily closed without disturbing fiber
Step 2
or Ethernet patchcords.
To check that the FMEC cover is seated correctly, verify that it can be easily closed without disturbing
Step 3
cables.
Step 4 Return to your originating procedure (NTP).
DLP-D33 Measure Voltage
Purpose
Tools/Equipment
Prerequisite Procedures Complete
Required/As Needed
Onsite/Remote
Security Level
Using a voltmeter, verify the office ground and power:
Step 1
a.
b.
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-26
Use this task to inspect the shelf installation and connections and verify that
everything is installed and connected properly.
None
Required
Onsite
None
Use this task to measure the power to verify correct power and returns.
Voltmeter
Required
Onsite
None
Place the black lead (positive) on the frame ground on the bay. Hold it there while completing
Step b.
Place the red lead (negative) on the fuse power points on the third-party power distribution panel to
verify that they read between –40.5 VDC and –57 VDC (power) and 0 (return ground).
Table 1-2 on page 1-19.
Chapter 1, "Install the Shelf and FMECs,"
Table 1-2 on page 1-19.
Chapter 17 DLPs D1 to D99
to correct it.
78-17194-01