Cisco ONS 15454 SDH Procedure Manual page 168

NTP- D344 Open-Ended SNCP Acceptance Test
Connect the test set receive (Rx) connector to the circuit transmit (Tx) connector.
b.
Verify that the test set shows a clean signal. If a clean signal does not appear, repeat Steps
Step 13
to make sure the test set and cabling are configured correctly.
Inject BIT errors from the test set. To verify that you have a complete end-to-end circuit, verify that the
Step 14
errors appear at the test set.
Step 15 Complete the
Step 16 Complete the
From the View menu, choose Go to Network View.
Step 17
Click one of the two spans leaving the circuit source node.
Step 18
Complete the
Step 19
protection switching function on this span.
In network view, click the other circuit source span and repeat
Step 20
Set up and complete a BER test. Use the existing configuration and follow your site requirements for the
Step 21
length of time. Record the test results and configuration.
Step 22 Complete the
Remove any loopbacks, switches, or test sets from the nodes after all testing is complete.
Step 23
In network view, click the Alarms tab.
Step 24
Verify that the alarm filter is not on. See the
a.
page 19-25
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
b.
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
Complete the
c.
In network view, click the Conditions tab.
Step 25
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
a.
resolve them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if
necessary.
b. Complete the
information.
Step 26 Repeat Steps
third-party network.
If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
Step 27
again, refer to the next level of support.
After all tests are successfully completed and no alarms exist in the network, the network is ready for
service application. Continue with
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-38
"DLP-D254 TCC2/TCC2P Card Active/Standby Switch Test" task on page
"DLP-D255 Cross-Connect Card Side Switch Test" task on page
"DLP-D94 SNCP Protection Switching Test" task on page 17-91
"DLP-D27 Delete Circuits" task on page 17-21
as necessary.
"DLP-D147 Export CTC Data" task on page 18-38
"DLP-D147 Export CTC Data" task on page 18-38
6 through 25 for each node that will be a source or destination for circuits traversing the
Chapter 6, "Create Circuits and Low-Order Tunnels."
Step 19.
for the test circuit.
"DLP-D227 Disable Alarm Filtering" task on
to export the alarm information.
to export the conditions
Chapter 5 Turn Up a Network
1 through 8
19-59.
19-60.
to test the SNCP
78-17194-01