Dlp- D30 Repair An Ip Tunnel - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
DLP-D30 Repair an IP Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures See
Required/As Needed
Onsite/Remote
Security Level
Step 1 Obtain the original IP address of the node in question.
Step 2 From the View menu, choose Go to Network View.
From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step 3
Review the text in the IP Repair wizard and click Next.
Step 4
In the Node IP address area, complete the following:
Step 5
•
•
Click Next.
Step 6
Click Finish.
Step 7
Return to your originating procedure (NTP).
Step 8
DLP-D31 Delete Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting overhead circuits is service affecting if the circuit ports are in the Unlocked-enabled service
Caution
state. To place circuit ports in the Locked-enabled,disabled service state, see the
the Service State for a Port" task on page
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Overhead Circuits tabs.
Step 2
78-17194-01
This task repairs circuits that are in the PARTIAL status as a result of node
IP address changes.
None
creation procedures.
As needed
Onsite or remote
Provisioning or higher
Node—Choose the node that has a PARTIAL circuit.
Old IP Address—Type the node's original IP address.
This task deletes overhead circuits. Overhead circuits include DCC
tunnels, IP-encapsulated tunnels, the AIC-I card orderwire, and the AIC-I
card user data channel (UDC).
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Chapter 6, "Create Circuits and Low-Order Tunnels"
19-10.
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D30 Repair an IP Tunnel

for circuit
"DLP-D214 Change
17-25