Ntp- D301 Monitor Fc_Mr-4 Performance - Cisco ONS 15454 SDH Procedure Manual

NTP- D301 Monitor FC_MR-4 Performance

To refresh, reset, or clear PM counts, see the
Note
page
Stop. You have completed this procedure.
NTP-D301 Monitor FC_MR-4 Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with Step 2.
Complete the
Step 2
Complete the
Step 3
Step 4 Complete the
Stop. You have completed this procedure.
NTP-D302 Create or Delete FC_MR-4 RMON Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Cisco ONS 15454 SDH Procedure Guide, R7.0
8-6
8-2.
This procedure enables you to view node transmit and receive
performance during selected time intervals on an FC_MR-4 card and
port to detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Low-Order Tunnels"
As needed
Onsite or remote
Retrieve or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D460 View FC_MR-4 Statistics PM Parameters" task on page
"DLP-D461 View FC_MR-4 Utilization PM Parameters" task on page
"DLP-D462 View FC_MR-4 History PM Parameters" task on page
This procedure creates or deletes FC_MR-4 RMON thresholds for the
ONS 15454 SDH.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page
"NTP-D257 Change the PM Display" procedure on
and Chapter 10, "Change Card Settings."
at the node that you want to monitor. If you
17-49. If you are already logged in, continue with
Chapter 8 Monitor Performance
Chapter 6, "Create Circuits
21-37.
21-38.
21-39.
78-17194-01