Dlp- D393 Switch Between Tdm And Dwdm Network Views - Cisco ONS 15454 SDH Procedure Manual

DLP- D393 Switch Between TDM and DWDM Network Views

Record on paper the byte that appears in the MS-SPR Ext Byte column.
Step 4
Repeat Steps
Step 5
If the node at the other end of the new span contains OC48 LS/STM16 LH AS trunk cards, repeat Steps
Step 6
through
to the K3 extension byte. Continue with
Step 7 If the trunk cards on each end of the new span are mapped to the same MS-SPRing extension byte,
continue with
nodes. See the
Return to your originating procedure (NTP).
Step 8
DLP-D393 Switch Between TDM and DWDM Network Views
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Step 2 From the Network Scope drop-down list, choose one of the following:
•
•
•
Return to your originating procedure (NTP).
Step 3
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-82
2 through 4 for the second OC48 LS/STM16 LH AS trunk card.
5 at the node. If it does not have OC48 LS/STM16 LH AS cards, their trunk cards are mapped
Step 8. If they are not the same, remap the extension byte of the trunk cards at one of the
"DLP-D89 Remap the K3 Byte" task on page
This task switches the CTC view between time-division multiplexing
(TDM) and DWDM network views. To provision DWDM networks, refer
to the Cisco ONS 15454 DWDM Procedure Guide.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
All—Displays both TDM and DWDM nodes.
TDM—Displays only ONS 15454 SDH nodes with SDH cards including the transponder (TXP) and
muxponder (MXP) cards.
DWDM—Displays only ONS 15454 SDH nodes with DWDM cards, including the TXP and MXP
cards.
Note For information about DWDM, TXP, and MXP cards, refer to the Cisco ONS 15454 DWDM
Reference Manual.
Step 7.
17-83.
Chapter 20 DLPs D300 to D399
1
78-17194-01