Dlp- D461 View Fc_Mr-4 Utilization Pm Parameters - Cisco ONS 15454 SDH Procedure Manual

DLP- D461 View FC_MR-4 Utilization PM Parameters

DLP-D461 View FC_MR-4 Utilization PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
Step 1
appears.
Step 2 Click the Performance > Utilization tabs
Figure 21-12
Card View
Performance
Utilization
Click Refresh. Performance monitoring utilization values for each port on the card appear.
Step 3
View the port number column to find the port you want to monitor.
Step 4
The transmit (Tx) and receive (Rx) bandwidth utilization values for the previous time intervals appear
Step 5
in the Prev-n columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in
the Cisco ONS 15454 SDH Reference Manual.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-38
This task enables you to view line utilization PM counts on an FC_MR-4
card and port to detect possible performance problems.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
FC_MR-4 Utilization in the Card View Performance Window
tab
tab
Interval
drop-down list
(Figure 21-12).
Refresh
button
Chapter 21 DLPs D400 to D499
78-17194-01