Ntp- D284 Create A Manually Routed Vcat Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
Click Finish. The Circuits window appears.
Step 16
Note
In the Circuits window, verify that the circuit you created appear in the circuits list.
Step 17
Stop. You have completed this procedure.
NTP-D284 Create a Manually Routed VCAT Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
If you want to assign a name to the tunnel source and destination ports before you create the circuit,
Step 2
complete the
automatically based on circuit type, node name, and sequence number, continue with
Step 3 Complete the following as necessary (you can provision Ethernet or POS ports before or after the VCAT
circuit is created):
•
•
•
•
•
From the View menu, choose Go to Network View.
Step 4
In the Circuit Creation dialog box, choose VC_HO_PATH_VCAT_CIRCUIT from the Circuit Type
Step 5
drop-down list.
Click Next.
Step 6
78-17194-01
Depending on the complexity of the network and number of members, the VCAT circuit creation
process might take several minutes.
This procedure creates a manually routed VCAT circuit. For more
information about VCAT circuits, refer to the "Circuits and Tunnels"
chapter of the Cisco ONS 15454 SDH Reference Manual.
ML-Series, CE-100T-8, CE-1000-4, or FC_MR-4 cards must be installed
at the nodes used in the VCAT circuit.
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D314 Assign a Name to a Port" task on page
To provision Ethernet ports for CE-100T-8 circuits, complete the
Ethernet Ports" task on page
To provision Ethernet ports for CE-1000-4 circuits, complete the
Ethernet Ports" task on page
To provision POS ports for CE-100T-8 or CE-1000-4 circuits, complete the
CE-100T-8 and CE-1000-4 POS Ports" task on page
To provision Ethernet ports for ML-Series circuits, complete the
Port of the ML-Series Card" task on page
To provision POS ports for ML-Series circuits, complete the
the ML-Series Card" task on page
at the node where you will create the circuit.
Step 2.
18-30.
19-8.
18-33.
21-49.
21-50.
Cisco ONS 15454 SDH Procedure Guide, R7.0

NTP- D284 Create a Manually Routed VCAT Circuit

20-7. If you want CTC to assign a name
Step
"DLP-D136 Provision CE-100T-8
"DLP-D211 Provision CE-1000-4
"DLP-D141 Provision
"DLP-D493 Provision the Ethernet
"DLP-D494 Provision the POS Port of
5.
6-101