Table of Contents
Advertisement
DLP- D40 Create a Provisionable Patchcord
In node view, click the Provisioning > Comm Channels > PPC tabs. If you are in network view, click
Step 1
the Provisioning > Provisionable Patchcords tabs.
Click Create. The Provisionable Patchcord dialog box appears.
Step 2
In the Origination Node area, complete the following:
Step 3
If you are in node view, the Origination Node defaults to the current node. If you are in network
a.
view, click the desired origination node from the drop-down list.
Type a patchcord identifier (0 through 32767) in the TX/RX ID field.
b.
Click the desired origination slot/port from the list of available slots/ports.
c.
In the Termination Node area, complete the following:
Step 4
Click the desired termination node from the drop-down list. If the remote node has not previously
a.
been discovered by CTC but is accessible by CTC, type the name of the remote node.
Type a patchcord identifier (0 through 32767) in the TX/RX ID field. The origination and
b.
termination IDs must be different if the patchcord is set up between two cards on the same node.
Click the desired termination slot/port from the list of available slots/ports. The origination port and
c.
the termination port must be different.
If you need to provision Tx and Rx separately for multiplexer/demultiplexer cards, check the
Step 5
Separate Tx/Rx check box. If not, continue with
already provisioned. Complete the following to provision the RX ports:
In the Origination Node area, type a patchcord identifier (0 through 32767) in the RX ID field. The
a.
origination Tx and Rx and termination Tx and Rx IDs must be different.
Click the desired origination slot/port from the list of available slots/ports.
b.
In the Termination Node area, type a patchcord identifier (0 through 32767) in the RX ID field. The
c.
origination Tx and Rx and termination Tx and Rx IDs must be different.
Click the desired termination slot/port from the list of available slots/ports.
d.
Click OK.
Step 6
Step 7
If you provisioned a patchcord on a port in a 1+1 protection group, a dialog box appears to ask if you
would like to provision the peer patchcord. Click Yes. Repeat Steps
Return to your originating procedure (NTP).
Step 8
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-32
Step
6. The origination and termination TX ports are
3
through
Chapter 17
DLPs D1 to D99
6
for the peer patchcord.
78-17194-01
Advertisement
Chapters
Table of Contents
