Dlp- D261 Refresh Pm Counts For A Different Port - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
DLP-D261 Refresh PM Counts for a Different Port
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the STM-N card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
In the Port drop-down list, choose a port.
Step 3
Click the Refresh button. The PM counts for the newly selected port appear.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-D262 Filter the Display of Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
•
•
•
Click the Circuits tab.
Step 2
Set the attributes for filtering the circuit display:
Step 3
a.
b.
78-17194-01
This task filters the display of circuits in the Circuits window. The filtered
display appears in network, node, or card view.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
To filter network circuits, from the View menu, choose Go to Network View.
To filter circuits that originate, terminate, or pass through a specific node, from the View menu,
choose Go to Other Node, then choose the node you want to filter and click OK.
To filter circuits that originate, terminate, or pass through a specific card, double-click the card on
the shelf graphic in node view to show the card in card view.
Click Filter.
In the General tab of the Circuit Filter dialog box, set the following filter attributes, as necessary:
• Name—Enter a complete or partial circuit name to filter circuits based on the circuit name;
otherwise leave the field blank.
This task changes the window view to display PM counts for another
port on a multiport card.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D261 Refresh PM Counts for a Different Port

19-65