Dlp- D175 Remove A Tarp Manual Adjacency Table Entry - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
Provision the other tunnel endpoint using the documentation.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D175 Remove a TARP Manual Adjacency Table Entry
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If TARP manual adjacency is the only means of communication to a group of nodes, loss of visibility
Caution
will occur when the adjacency table entry is removed.
In node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 1
Click the MAT entry that you want to delete.
Step 2
Click Remove.
Step 3
In the Delete TDC Entry dialog box, click OK.
Step 4
Step 5 Return to your originating procedure (NTP).
DLP-D176 Convert E1-N-14 Cards From 1:1 to 1:N Protection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This procedure assumes that E1-N-14 cards are installed in Slots 1 through 6 and/or Slots 12 through 17.
Note
The E1-N-14 cards in Slots 3 and 15 are the protect cards. Each protect card protects the other E1-N-14
cards in that half of the shelf. The ONS 15454 SDH must run CTC Software Release 4.0 or later.
In node view, click the Maintenance > Protection tabs.
Step 1
78-17194-01
This task removes an entry from the TARP manual adjacency table.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
This task converts E1-N-14 cards in a 1:1 protection scheme to 1:N
protection. A 1:N protection group can protect a maximum of five working
cards.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite
Provisioning or higher

DLP- D175 Remove a TARP Manual Adjacency Table Entry

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-63