Dlp- D178 Change The Osi Routing Mode - Cisco ONS 15454 SDH Procedure Manual

DLP- D178 Change the OSI Routing Mode

Click Create.
Step 15
(Optional) Type a name for the protection group in the Name field.
Step 16
Click Type and choose 1:N (card) from the drop-down list.
Step 17
Verify that the DS3i-N-12 card appears in the Protect Card field.
Step 18
In the Available Cards list, highlight the cards that you want in the protection group. Click the arrow
Step 19
(>>) tab to move the cards to the Working Cards list.
Click OK.
Step 20
The protection group should appear in the Protection Groups list on the Protection subtab.
Return to your originating procedure (NTP).
Step 21
DLP-D178 Change the OSI Routing Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Do not complete this procedure until you confirm the role of the node within the network. It will be either
an ES, IS Level 1, or IS Level 1/Level 2. This decision must be carefully considered. For additional
information about OSI provisioning, refer to the "Management Network Connectivity" chapter of the
Cisco ONS 15454 SDH Reference Manual.
Caution LSP buffers must be the same at all NEs within the network, or loss of visibility could occur. Do not
modify the LSP buffers unless you are sure that all NEs within the OSI have the same buffer size.
LSP buffer sizes cannot be greater than the LAP-D MTU size within the OSI area.
Caution
Verify the following:
Step 1
•
•
•
In node view, click the Provisioning > OSI tabs.
Step 2
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-66
This task changes the OSI routing mode.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
All L1/L2 virtual routers on the NE must reside in the same area. This means that all neighboring
virtual routers must have at least one common area address.
For OSI L1/L2 to ES routing mode changes, only one L1/L2 virtual router and no more than one
subnet can be configured.
For OSI L1 to ES routing mode changes, only one L1 virtual router and no more than one subnet
can be configured.
Chapter 18 DLPs D100 to D199
78-17194-01