Cisco ONS 15454 SDH Procedure Manual page 148

NTP- D304 Provision a Traditional MS-SPRing Dual-Ring Interconnect
At Node 2, repeat Steps
Step 21
the east STM-N trunk card of Node 2 (Node 3). Work your way around the MS-SPRing creating test
circuits between every two consecutive nodes.
After you test the entire ring, remove any loopbacks and test sets from the nodes.
Step 22
Step 23 Click the Alarms tab.
a.
b.
c.
Click the Conditions tab.
Step 24
a.
b.
If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
Step 25
again, refer to the next level of support.
After all tests are successfully completed and no alarms exist in the network, the network is ready for
service application. Continue with
Stop. You have completed this procedure.
NTP-D304 Provision a Traditional MS-SPRing Dual-Ring
Interconnect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note To route circuits on the DRI, you must check the Dual Ring Interconnect check box during circuit
creation.
Step 1 Complete the
Step 2.
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-18
5 through 20, creating a test circuit between Node 2 and the node connected to
Verify that the alarm filter is not on. See the
page 19-25 as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
Complete the "DLP-D147 Export CTC Data" task on page 18-38
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if
necessary.
Complete the "DLP-D147 Export CTC Data" task on page 18-38
This procedure provisions MS-SPRings in a traditional dual-ring
interconnect (DRI) topology. DRIs interconnect two or more MS-SPRings
to provide an additional level of protection. Two-fiber and four-fiber
MS-SPRings can be mixed in a traditional MS-SPRing DRI network.
None
NTP-D35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page
"DLP-D227 Disable Alarm Filtering" task on
Chapter 6, "Create Circuits and Low-Order Tunnels."
17-49. If you are already logged in, continue with
Chapter 5 Turn Up a Network
to export alarm information.
to export conditions information.
78-17194-01