Figure - Cisco ONS 15454 SDH Procedure Manual

NTP- D69 View Alarm-Affected Circuits
NTP-D69 View Alarm-Affected Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
In network, node, or card view, click the Alarms tab or Conditions tab and then right-click anywhere
Step 2
in the row of an active alarm or condition.
Note
The Select Affected Circuit option appears in the shortcut menu

Figure 9-1

Click Select Affected Circuits.
Step 3
Cisco ONS 15454 SDH Procedure Guide, R7.0
9-4
Use this procedure to view all circuits, if any, that are affected by an alarm
or condition.
None
NTP-D196 View Alarms, History, Events, and Conditions, page 9-2
As needed
Onsite or remote
Retrieve or higher
"DLP-D60 Log into CTC" task on page
2.
The node view is the default, but you can also navigate to the Alarms tab in the network view or
card view to perform Step 2.
Select Affected Circuits Option
Chapter 9
17-49. If you are already logged in, continue with
(Figure 9-1).
Manage Alarms
78-17194-01