Cisco ONS 15454 SDH Procedure Manual page 450

DLP- D45 Install the Fiber Boot
If you are installing an STM1SH 1310-8 card, you must use a fiber clip instead of a fiber boot on the
Note
Port 8 Rx fiber connector.
Position the open slot of the fiber boot underneath the fiber cable.
Step 1
Push the fiber cable down into the fiber boot.
Step 2
Figure 17-9
Strain relief shroud
Step 3 Twist the fiber boot to lock the fiber cable into the tail end of the fiber boot.
Step 4 Slide the fiber boot forward along the fiber cable until the fiber boot fits snugly onto the end of the
SC cable connector.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-36
Attaching a Fiber Boot
SC cable
connector
Fiber
optic
line Fiber boot
Figure 17-9 shows the fiber boot attachment.
Chapter 17 DLPs D1 to D99
78-17194-01