Table of Contents
Advertisement
Figure 3: Closing the retaining latches on the front of a blade
Step two: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a
hub, to minimize interference from other devices on the network). The Ethernet
port is a 10/100/1000 Mbps auto-sensing connection.
Ethernet Ports B, C and D may not be supported in the software supplied
i
with your blade. Do not connect to these ports unless the web interface
allows you to configure them. Do not connect multiple ports to the same
subnet unless instructed to do so by the web interface.
Installing the MCU MSE 8510
7
Advertisement
Table of Contents
