Dlp- D186 Provision A Low-Order Vc11 Circuit Source And Destination - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
DLP-D186 Provision a Low-Order VC11 Circuit Source and Destination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
After you have selected the circuit properties in the Circuit Source dialog box according to the specific
Note
circuit creation procedure, you are ready to provision the circuit source.
From the Node drop-down list, choose the node where the source will originate.
Step 1
From the Slot drop-down list, choose the slot containing the STM-N or MRC-12 card where the circuit
Step 2
will originate
transport.
Figure 18-11
Choose the port from the Port drop-down list.
Step 3
78-17194-01
This task provisions an optical circuit source and destination for a
low-order VC11 circuit.
None
DLP-D60 Log into CTC, page 17-49
NTP-D334 Create an Automatically Routed Low-Order VC11 Circuit,
page 6-7, or
NTP-D335 Create a Manually Routed Low-Order VC11 Circuit, page
6-12, or
NTP-D336 Create a Unidirectional Low-Order VC11 Circuit with
Multiple Drops, page 6-15
You must have the Source page of the Circuit Creation wizard open.
As needed
Onsite or remote
Provisioning or higher
(Figure 18-11). If you choose an STM-N card, you can map the VC11 to VC4 for optical
Defining the Circuit Source on an STM-16 Card

DLP- D186 Provision a Low-Order VC11 Circuit Source and Destination

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-73