Cisco ONS 15454 SDH Procedure Manual page 696

DLP- D324 Install Alarm Cables on the MIC-A/P
Figure 20-4
FMEC cover
Hinge-locking
Detach the cover from the pin of the hinge.
Step 4
Remove the cover carefully from the left pin of the hinge.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D324 Install Alarm Cables on the MIC-A/P
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wires, connect the alarm and control wires on the
Step 1
appropriate pins of the DB-62 connector. The pin connectors, signal names, and functions are listed in
Table
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-12
Removing the ONS 15454 SDH FMEC Cover
Pin hinge
spring
This task installs alarm cables on the MIC-A/P FMEC so that you can
provision external (environmental) alarms and controls with the AIC-I
card.
DB-62 connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) wires
NTP-D220 Install the Power and Signal FMECs, page 1-7
As needed
Onsite
None
20-1.
F A N
F A IL
C R
IT
M A
J
M IN
Chapter 20 DLPs D300 to D399
78-17194-01