Dlp- D342 Change Line And Threshold Settings For The Stm1E-12 Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
DLP-D342 Change Line and Threshold Settings for the STM1E-12 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
For the default values and domains of user-provisionable card settings, refer to the "Network Element
Note
Defaults" appendix in the Cisco ONS 15454 SDH Reference Manual.
In node view, double-click the STM1E-12 card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
Step 3 Depending on the setting you need to modify, click the Line, Port, SDH Thresholds, or VC4 subtab.
Note
Note
Modify any of the settings found under these subtabs by clicking in the field you want to modify. In some
Step 4
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
Click Apply.
Step 5
Repeat Steps
Step 6
For definitions of the line settings, see
Step 7
on page
of the VC4 settings, see
Table 20-22
Table 20-22
Parameter
Port
Port Name
78-17194-01
This task changes the line and threshold settings for the STM1E-12 card.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
See Chapter 9, "Manage Alarms"
If you want to modify a threshold setting, it might be necessary to click on the available
directional, type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will
display the desired threshold setting.
3 through 5 for each subtab that has parameters you want to provision.
20-52. For definitions of the threshold settings, see
Table 20-25 on page
describes the values on the Provisioning > Line tab for the STM1E-12 cards.
Line Options for the STM1E-12 Card
Description
(Display only) Port number.
(Optional) Sets the name assigned to
the port.

DLP- D342 Change Line and Threshold Settings for the STM1E-12 Card

for information about the Alarm Profiles tab.
Table 20-22. For definitions of the port settings, see
Table 20-24 on page
20-53.
Options
1 to 12
User-defined, up to 32 alphanumeric/special
characters. Blank by default.
See the "DLP-D314 Assign a Name to a Port"
task on page
Cisco ONS 15454 SDH Procedure Guide, R7.0
Table 20-23
20-53. For definitions
20-7.
20-51