Ntp- D88 Modify Line Settings And Pm Parameter Thresholds For Electrical Cards - Cisco ONS 15454 SDH Procedure Manual

NTP- D88 Modify Line Settings and PM Parameter Thresholds for Electrical Cards

NTP-D88 Modify Line Settings and PM Parameter Thresholds for
Electrical Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Changing card settings can be service affecting. You should make all changes during a scheduled
Caution
maintenance window.
Complete the
Step 1
electrical card settings. If you are already logged in, proceed to Step 2.
As needed, complete the
Step 2
existing database.
Perform any of the following tasks as needed:
Step 3
•
•
•
•
Note
As needed, complete the
Step 4
Stop. You have completed this procedure.
NTP-D89 Modify Line Settings and PM Parameter Thresholds for
Optical Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Cisco ONS 15454 SDH Procedure Guide, R7.0
10-2
This procedure changes the line settings and performance monitoring (PM)
parameter thresholds for electrical cards.
None
NTP-D17 Install the Electrical Cards, page 2-10
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"NTP-D108 Back Up the Database" procedure on page 15-5
DLP-D365 Change Line and Threshold Settings for E1-N-14 or E1-42 Cards, page 20-39
DLP-D340 Change Line and Threshold Settings for the E3-12 Cards, page 20-43
DLP-D341 Change Line and Threshold Settings for the DS3i-N-12 Cards, page 20-47
DLP-D342 Change Line and Threshold Settings for the STM1E-12 Card, page 20-51
To change settings on the Alarm Profiles tab, see
"NTP-D108 Back Up the Database" procedure on page
This procedure changes the line settings and the PM parameter thresholds
for optical (STM-N) cards.
None
NTP-D16 Install STM-N Cards and Connectors, page 2-7
As needed
Chapter 10
at the node where you want to change the
Chapter 9, "Manage Alarms."
15-5.
Change Card Settings
to preserve the
78-17194-01