Dlp- D326 Install Lan Wires On The Mic-C/T/P - Cisco ONS 15454 SDH Procedure Manual

DLP- D326 Install LAN Wires on the MIC-C/T/P

DLP-D326 Install LAN Wires on the MIC-C/T/P
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Rather than using the LAN connection port on the MIC-C/T/P, you can use the LAN connection port on
Note
the TCC2/TCC2P card if preferred. Use either the MIC-C/T/P connection or the TCC2/TCC2P card
connection. You cannot use the LAN connection port on the MIC-C/T/P and the LAN connection port
on the TCC2/TCC2P card simultaneously; however, it is possible for you to make a direct connection
from a computer to the LAN connection port on the TCC2/TCC2P card while the LAN connection port
on the MIC-C/T/P is in use as long as the computer connected directly to the TCC2/TCC2P card is not
connected to the same LAN.
Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire or CAT-5 UTP Ethernet cable, connect the wires
Step 1
to the RJ-45 connector according to
Table 20-3
LAN
LAN 1
Connecting to DCE
(a hub or switch)
Cross-over Ethernet cable
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-16
This task installs the LAN wires on the MIC-C/T/P FMEC.
Standard CAT-5 unshielded twisted-pair (UTP) Ethernet cable
(straight-through for data terminal equipment [DTE] or cross-over for data
circuit-terminating equipment [DCE])
or
RJ-45 connector
Crimping tool for RJ-45 connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire, preferably CAT-5 UTP
NTP-D220 Install the Power and Signal FMECs, page 1-7
As needed
Onsite
None
Table 20-3
LAN Pin Assignments
RJ-45 Pin
1
1
2
3
4
5
6
7
8
and crimp the connector to the cable.
RJ-45 Pin
3
6
1
4
5
2
7
8
Chapter 20 DLPs D300 to D399
Function
PNMSRX+
white/green
PNMSRX–
green
PNMSTX
white/orange
—
—
PNMSTX–
orange
—
—
78-17194-01