Dlp- D34 Delete Vlans - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
Using a voltmeter, verify the shelf ground and power wiring:
Step 2
a.
Repeat
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-D34 Delete VLANs
Purpose
Tools/Equipment
Prerequisite Procedures Circuit creation procedure(s) in
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
From the Tools menu, choose Manage VLANS.
Step 2
In the All VLANs dialog box, click the VLAN that you want to remove.
Step 3
Click Delete.
Step 4
In the confirmation dialog box, click Yes.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D35 Delete a Node from the Current Session or Login Group
Purpose
Tools
Prerequisite Procedures
Required/As Needed
78-17194-01
Place the black lead (positive) on the RET1 and the red lead on the BAT1 point. Verify a reading
between –40.5 VDC and –57 VDC. If there is no voltage, check the following and correct if
necessary:
• Battery and ground reversed to the shelf.
• Battery is open or missing.
• Return is open or missing.
Step 1 and Step 2 for the RET2 and BAT2 of the redundant power supply input.
This task removes VLANs from a domain.
None
Low-Order Tunnels."
As needed
Onsite or remote
Provisioning or higher
This task removes a node from the current CTC session or login node
group. To remove a node from a login node group that is not the current
one, see
task on page
None
DLP-D60 Log into CTC, page 17-49
As needed
Chapter 6, "Create Circuits and
"DLP-D54 Delete a Node from a Specified Login Node Group"
17-47.
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D34 Delete VLANs

17-27