Dlp- D427 Delete Alarm Severity Profiles - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
DLP-D427 Delete Alarm Severity Profiles
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Access the alarm profile editor:
Step 1
•
•
•
•
Click the profile you are deleting to select it.
Step 2
Click Delete.
Step 3
The Select Node/Profile Combination for Delete dialog box appears
Figure 21-5
Note
78-17194-01
This task deletes a custom or default alarm severity profile.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
From network view, click the Provisioning > Alarm Profiles tabs.
From node view, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
From card view, if the card is an FC_MR-4, E-Series Ethernet, G-Series Ethernet, STM-N, or
electrical (DS3i-N-12, E-1, E1-42, or E-3) card, click the Provisioning > Alarm Profiles >
Alarm Profile Editor tabs.
If the card is an ML-Series Ethernet (traffic) card, click the Provisioning > Ether Alarming >
Alarm Profile Editor tabs or the Provisioning > POS Alarming > Alarm Profile Editor tabs,
depending on whether you want to apply the profile to the front physical ports ("Ether alarming")
or packet over SDH ("POS alarming"). For more information about ML-Series card ports and
service, see the Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
Select Node/Profile Combination For Delete Dialog Box
You cannot delete the Inherited or Default alarm profiles.

DLP- D427 Delete Alarm Severity Profiles

(Figure 21-5).
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-11