Figure 5-11 Ons 15454 Sdh Open-Ended Sncps Fiber Connection Example; Ntp- D258 Provision An Open-Ended Sncp - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:

Table of Contents

Turn Up a Network

Verify that the third-party cards or units to which the ONS 15454 SDH trunk cards are connected are the

same STM-N rate as the ONS 15454 SDH trunk cards. The third-party time slots must match the

ONS 15454 SDH card time slots to which they are connected. For example, if your trunk card is an

STM-16, the third-party vendor card or unit must have VC4s 1 to 8 available.

Log into an ONS 15454 SDH in the SNCP you are turning up. See the

Complete the

the ONS 15454 SDH cards/ports that are connected to another ONS 15454 SDH. (Alternatively, if

additional bandwidth is needed for CTC management, complete the

Multiplex-Section DCC Terminations" task on page

termination for the card/port that connects to the third-party equipment. For example, in

DCC terminations are created at the following cards/ports:

Nodes 1 and 6: Slot 5 and Slot 12

Node 2 and 5: Slot 12

ONS 15454 SDH Open-Ended SNCPs Fiber Connection Example

17-49. If you are already logged in, continue with Step 4.

"DLP-D363 Provision Regenerator-Section DCC Terminations" task on page 20-68

20-71.) Do not create a DCC or MS-DCC

Cisco ONS 15454 SDH Procedure Guide, R7.0

"DLP-D60 Log into CTC" task

"DLP-D364 Provision

Chapters

Table of Contents