Ntp- D350 Create A Server Trail - Cisco ONS 15454 SDH Procedure Manual

NTP- D350 Create a Server Trail

Stop. You have completed this procedure.
NTP-D350 Create a Server Trail
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You cannot create server trails on ports with DCC links.
Note
Step 1 Complete the
If you are already logged in, continue with
Step 2 From the View menu, choose Go to Network View.
Step 3 Click the Provisioning > Server Trails tabs.
Step 4 Click Create.
Step 5 In the Server Trail Creation dialog box, complete the following fields:
•
•
•
•
•
Step 6 Click Next.
Step 7 In the Source area, complete the following:
a.
b.
c.
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-106
This procedure creates a server trail, which provides a connection between
ONS nodes through a third-party network. You can create server trails
between any two STM-N or EC1 ports.
None
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Type—Choose VC_HO_PATH_CIRCUIT or VC_LO_PATH_CIRCUIT.
Size—Depending on the type selected, choose the server trail size. For VC_HO_PATH_CIRCUIT,
choose VC4-2c, VC4-3c, VC4-4c, VC4-6c, VC4-8c, VC4-12c, VC4-16c, VC4-64c, or VC4. For
VC_LO_PATH_CIRCUIT, choose VC3, VC12, or VC11.
Protection Type—Choose one of the following protection types: Preemptible, Unprotected, or
Fully Protected. The server trail protection determines the protection type for any circuits that
traverse it.
Number of Trails—Enter the number of server trails. You can create multiple server trails from the
same port. The maximum number is determined by how many circuits of a particular server trail size
can be supported on the port.
SRLG—Enter a value for the Shared Resource Link Group (SRLG). SRLG is used by
Cisco Transport Manager (CTM) to specify link diversity. The SRLG field has no restrictions. If you
create multiple server trails from one port, you can assign the same SRLG value to all the links to
indicate that they originate from the same port.
From the Node drop-down list, choose the node where the source will originate.
From the Slot drop-down list, choose the slot.
From the Port drop-down list, choose the port.
Chapter 6
at the node where you will create the circuit.
Step 2.
Create Circuits and Low-Order Tunnels
78-17194-01